Scale is not reading

Fix a counter scale that shows no weight, and deli or produce labels that ring the wrong price.

TroubleshootingUpdated

The till shows no weight#

  1. Check the connection type in Store Management → This Till → Terminal Settings → Weight Scale. Only Network (IP / Ethernet) scales are read in this version. A Serial (COM port) or USB scale will show no weight — replace it with a network scale or ask BuiltPOS support.
  2. Check Enable weight scale on this terminal is on and you tapped Save.
  3. Check the IP Address and Port match the scale (see the scale's network settings or manual).
  4. Check Protocol matches the scale: NCI / SCP-01 (Brecknell, generic), Mettler-Toledo (8217), CAS (PD-II / SW) or Avery Weigh-Tronix.
  5. Make sure the scale and till are on the same network, then switch the scale off and on. The till reconnects by itself.

The weight stops updating#

The till clears the weight if the scale stops answering for about two seconds, so it never sells at a frozen weight. Check the scale's network cable or Wi-Fi.

A deli or produce label rings the wrong price or isn't found#

  1. Open Store Management → Store Settings → Scale labels.
  2. Scan the label into Test a label. It shows the PLU and the price or weight it read.
  3. If it says Not a scale label for this layout., check Barcode format, Prefixes, PLU digits, Price / weight digits and Label has a price check digit against the scale's label setup.
  4. If the PLU is right but the item isn't found, add that PLU to the product's barcodes.
  5. A product whose exact barcode matches the label is rung as that product, not read as a scale label.

Setup steps: Set up a scale and scale labels.

Was this helpful?

Still need help?

Open a ticket from the app

In any BuiltSOFTHUB app, open Help & Support and choose Report a problem. Our replies appear under My tickets.

Email us

Write to support@builtsofthub.com. Tell us the store name and what you were doing when it happened.