Receipt printer is not printing

Fix receipts that don't print, print blank, are cut off on the left or have columns that don't line up.

TroubleshootingUpdated

Start with Store Management → This Till → Terminal Settings → Printer, and tap Test Print (or Test Connection). The message you get tells you where to look.

"Printer at … did not accept test ticket" or "Connection failed"#

The till cannot reach a network printer.

  1. Print the printer's own self-test page and check its IP address still matches IP Address in BuiltPOS. Printers often get a new address after a router restart — ask your installer to reserve the address.
  2. Check the Port (usually 9100).
  3. Make sure the till and printer are on the same network (the same Wi-Fi or router).
  4. Switch the printer off and on, then test again.

"No printers found" (Windows)#

  1. Open Windows Settings → Printers & scanners and check the printer is installed and online.
  2. If none show, the Windows Print Spooler service may be stopped — restart the computer.
  3. Back in BuiltPOS, tap the refresh icon next to the printer list.

Receipts stopped printing after a sale, but the test works#

Check Receipt Printing in the same section. If On Cash Payment (or the payment type you used) is set to Preview or Don't Print, the receipt only prints when you ask. Set it to Print to always print.

The left side is cut off, or the receipt is off-centre (Windows)#

Use Print alignment test and Move print left / right — see Fix a receipt that is cut off.

Columns don't line up, or the right edge is cut off#

  1. Check Paper Width matches the roll (80mm or 58mm).
  2. Change Characters per line from Auto (by paper width) to 48 (203dpi 80mm), 42 (180dpi 80mm) or 32 (58mm standard), test, and keep the one that fits.

Nothing prints on iPad or Android#

Tablets only print to a network (IP) printer or a Sunmi built-in printer. A Bluetooth or USB printer plugged into a tablet will not print. Switch to a network printer.

Sunmi: "Sunmi printer unavailable"#

Sunmi Built-in only works on a Sunmi Android device. On any other device choose Network (IP).

The printer row says "Assigned in BuiltOFFICE"#

That printer is managed in BuiltOFFICE; changes on the till are not allowed. Change it in BuiltOFFICE — see Kitchen stations and printers.

Still stuck?#

Note the exact message, the printer model and how it connects, and contact BuiltPOS support. Setup steps: Set up a receipt printer.

Was this helpful?

Still need help?

Open a ticket from the app

In any BuiltSOFTHUB app, open Help & Support and choose Report a problem. Our replies appear under My tickets.

Email us

Write to support@builtsofthub.com. Tell us the store name and what you were doing when it happened.